Outdoor Cleaning with Pressure Washers

Water Pump Maintenance

Step 1

Purging the pump of contaminants. Prepare the pressure washer for use. Turn on the supply water, then remove the wand from the spray gun. Start the engine, then squeeze and hold the spray-gun trigger until there is a constant, steady stream of water. Hold for 2 minutes, then engage the trigger safety latch and refasten the wand to the spray gun.

Water Pump Maintenance

Step 2

Changing pump oil. Drain the oil and fuel from the engine. Remove the oil cap on the water pump with an Allen wrench. Tilt the pressure washer to drain the used oil into an approved container. Tilt the unit back in the opposite direction after the oil has drained.

Water Pump Maintenance

Step 3

Changing pump oil. Fill the water pump with fresh oil, following the directions in the owner���s manual. Note: Premeasured bottles of water pump oil are available for some models. Reinstall the oil cap and tighten firmly, then wipe up any excess oil around the cap and set the pressure washer in the upright position. Clean up any spilled oil, and dispose of used oil and soiled rags in accordance with local environmental statutes.